LEM introduces open-loop Hall effect current transducers with digital outputs

 LEM is the market leader but also a pioneer to provide current and voltage sensors based on the latest technologies with analog or digital outputs !

Key points:

  • Compact open loop Hall effect current transducers with a digital output from a
  • sigma-delta modulator
  • 12 bits effective resolution with 20 kHz bandwidth
  • 10 MHz clock frequency
  • Same footprint and precision as LEM’s successful HLSR and HO analog series
  • Additional overcurrent detection output


LEM announces digital output versions of HO and HLSR open-loop Hall effect current transducers with analog to digital (A/D) conversion performed by an on-board sigma-delta modulator, giving a 1-bit serial bitstream output. These new components for nominal current measurements of 10, 32, 50, 80, 100, 120, 150, 200, 250 ARMS in 3 different mechanical designs (PCB and panel mounting) provide up to 12 bit resolution with 20 kHz bandwidth. The single-bit output minimizes the connections required, enabling highly compact transducers, and the digital output allows the user to choose the filter used on the bitstream to optimize between resolution and response time, according to the application. Digital outputs are also intrinsically immune to noise in hostile environments.

For a typical transfer function the average bitstream density is 50% for zero primary current, and 10% or 90% for maximum currents in the negative or positive directions.

In the first samples available in one mode the clock is output from the sensor at 10MHz and both the clock and the data are single-ended signals with CMOS levels. Alternatively the output may be Manchester coded on 2 pins, meeting the RS422 standard. The footprints of these sensors are the same as the analogue HLSR and HO transducer families.

The new transducers can use a supply voltage of 3.3 V or 5 V and the operating temperature range is from -40°C to +105°C.

Several different filters may be used on a given bitstream. As an example: if a sinc3 filter is used with an over-sampling ratio (OSR) of 128 the effective resolution of a 50 A sensor is 12 bits, and the response time is about 38µs.

Alternatively, a sinc2 filter with an OSR of 16 would give a response time of 4,6µs from the same bitstream, but the resolution would be reduced to 6 bits.Transducers in the HO family have additionally an Over-Current Detect (OCD) feature which measures the current level before the A/D converter. The response time of the OCD is 2us.

Future members of the family that are currently being developed will add 2 extra pins so both the clock and data may be differential signals that meet the RS422 and LVDS standards. Additionally, the transducer clock may be configured as an input in the range 5 – 12.5 MHz to allow a single clock to be used throughout the system. The single-ended and Manchester modes available today will still be supported.

Press information

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: